FAQ

Understanding bending, moving material in roll forming-1

Roll forming is a matter of two processes

08-10-17http://www.chineserollforming.com/FAQ/Roll forming/

Is metal roofing fabrication right for your shop? -6

Material Handling Options

08-10-17http://www.chineserollforming.com/FAQ/metal roofing fabrication/

Is metal roofing fabrication right for your shop-5

Line ConfigurationsFigure 4). Most new panel lines have a precut die. Precut dies use a common stationary or flying cutoff set for the maximum width, which provides versatility. Even a common stacker ..

08-10-14http://www.chineserollforming.com/FAQ/Line-Configurations/

Is metal roofing fabrication right for your shop? -4

Roof and wall panels are highly visible "appearance" components.

08-10-14http://www.chineserollforming.com/FAQ/Panel-Appearance/

Is metal roofing fabrication right for your shop-3

When deciding wheher or not to produce roofing panels, you need to determine your ROI, based on if you can use existing equipment or need new equipment, the required panel appearance; possible line co..

08-10-09http://www.chineserollforming.com/FAQ/Roll-former-for-good-sale/

Is metal roofing fabrication right for your shop-2

When deciding wheher or not to produce roofing panels, you need to determine your ROI, based on if you can use existing equipment or need new equipment, the required panel appearance; possible line co..

08-10-09http://www.chineserollforming.com/FAQ/Oil-expeller/

Is metal roofing fabrication right for your shop-I

How to ensure your roll forming operation is a good fit

08-10-08http://www.chineserollforming.com/FAQ/Oil-Press-Chinese-supplier/

Is metal roofing fabrication right for your shop-1

How to ensure your roll forming operation is a good fit

08-10-08http://www.chineserollforming.com/FAQ/Oil-Press/

A good start makes a difference-5

By ensuring your entrance guide is set to the correct elevation, you can reduce the stress and strain on formed parts and reduce the longitudinal elongation differential in the cross section.

08-10-08http://www.chineserollforming.com/FAQ/Fabricating-Roll-forming/

A good start makes a difference-4

Edge Bent up Model

08-10-07http://www.chineserollforming.com/FAQ/Roll-Former-supplier-in-China/