FAQ

Roll form tooling design for air bending-1

Several techniques are used commonly to reduce profile distortion when air bending with a roll former.

08-09-05http://www.chineserollforming.com/FAQ/Cold-Roll-Forming-Machine/

Selecting the right materials for roll forming—Part 13

High-speed slitting is the most economical way to cut wide mill coils into narrower strips.

08-09-04http://www.chineserollforming.com/FAQ/Roll-former-for-sale/

Selecting the right materials for roll forming—Part 12

Coil-coated finishes are available in several varieties

08-09-04http://www.chineserollforming.com/FAQ/Roofing-Tile-Forming-Machine/

Selecting the right materials for roll forming—Part 11

Thick cast metal slabs usually are hot-rolled to a minimum practical limit and then cold-rolled further to reduce thickness.

08-09-03http://www.chineserollforming.com/FAQ/Door-Frame-forming-machine/

Selecting the right materials for roll forming—Part 10

The mechanical and other properties of the wrought aluminum used for roll forming are influenced by the alloying elements, heat treatment, and cold work.

08-09-03http://www.chineserollforming.com/FAQ/Floor-Deckforming-machine/

Selecting the right materials for roll forming—Part9

By increasing the chromium and other elements in steel, it is possible to make it resistant to rust and/or heat.

08-09-02http://www.chineserollforming.com/FAQ/Sandwich-panel-line/

Selecting the right materials for roll forming—Part 8

If you examine the mechanical properties of several materials, including carbon steel, alloyed steel, stainless steel, as they relate to roll forming, you'll gain an understanding of the influence of ..

08-09-02http://www.chineserollforming.com/FAQ/Roll-cutting-machine/

Selecting the right materials for roll forming—Part 7

The most widely used metallic coating is zinc. Galvanized steel is produced when the steel is covered in molten zinc or zinc alloy, either by hot dipping or the electrolytic process.

08-09-01http://www.chineserollforming.com/FAQ/Roll-Formed-Products/

Selecting the right materials for roll forming—Part 6

To manufacture the right product at the right price, roll formers must have the right material. Selecting the best material for a job is an important and difficult task. The designer or material speci..

08-09-01http://www.chineserollforming.com/FAQ/Metal-forming-machine/

Selecting the right materials for roll forming—Part 5

This article presents some information about general and specific metal characteristics to assist roll formers in choosing the right metal.

08-08-29http://www.chineserollforming.com/FAQ/Tile-sheet forming-machine/